Take me to the Perimeter Protection Group website
Extranet
Crash bollards 1920x1080

New crash-test certification for fixed PPG bollard M50

PPG is pleased to announce that its fixed, shallow mounted M50 bollard which had (up until now) only been crash tested to ASTM F2656-07 resulting in an M50/P1 designation is now also available with PAS 68:2013 as well as IWA 14-1:2013 crash test certification following the successful arrest of a European flat bed truck N3/N3C travelling at 80 kph. This makes the fixed bollard M50 the fourth product from PPG’s comprehensive product range to bear a valid and genuine certification as per all three worldwide recognised crash test standards – i.e. ASTM F2656, PAS 68 and IWA 14-1 respectively. This furthermore increases the number of crash test certificates held by PPG to a staggering total of 28.

The crash test conditions for the fixed bollard remained unchanged in terms of installation details, i.e. the bollard was vehicle impact tested as triple unit with

– a centre distance of 1.5 m adhering to the 1.2 m maximum clear gap rule as stipulated by CPNI,
– a shallow, reinforced foundation of only 400 mm thickness and 2.5 by 4.5 m footprint and
– 100 mm road covering for customised road finish

The achieved performance classification of V/7500[N3]/80/90:0.4/15.4 and performance rating of V/7200[N3C]/80/90:0.8 are in line with the P1 penetration rating previously realised with the ASTM crash test. The slight increase in vehicle penetration comes as no surprise in view of the

– increased kinetic energy of the impacting truck due to the higher test vehicle weight and
– reduced “crush zone” in front of the vehicle datum point (i.e. the leading edge of the load platform) of the European truck compared to the American truck

For further information, watch the movie or get in touch with our sales department.